Kenwood K-821DV - Manual (Page 12)

K-821DV 12
Connecting the System
Connecting TV Monitor
Using video cable
Using HDMI cable
Connect the HDMI terminal on a TV monitor
to the [HDMI MONITOR OUT] terminal on
the rear panel of the main unit.
An HDMI/DVI converter cable is necessary to connect a TV monitor with a DVI input terminal. The TV monitor also z
needs to be compatible with HDCP (High-bandwidth Digital Contents Protection). Note that the video may be unable
to be monitored depending on the combined components.
Use an HDMI-certifi ed category 2 cable (High Speed HDMI™ Cable) for the connection. z
If the video and/or audio are not output normally, turn all of the connected components off then on, and try again. z
HDMI, the HDMI logo and High-Defi nition Multimedia Interface are
trademarks or registered trademarks of HDMI Licensing, LLC.
TV monitor
TV monitor
Video input
HDMI MONITOR IN
Connect the video input terminal on a TV
monitor to the [VIDEO MONITOR OUT] ter-
minal on the rear panel of the main unit us-
ing the video cord supplied with the system.
SPEAKERS
R
R
L L SUB WOOFER PRE OUT
DIGITAL OUT
REC OUT PLAY IN
D.AUDIO IN
SPEAKERS
R
R
L L SUB WOOFER PRE OUT
DIGITAL OUT
REC OUT PLAY IN
D.AUDIO IN
To select TV format „
In case of using video cable z
Press the 1. [ ] key to remove the disc from the unit, then close the tray.
Press and hold the 2. [ ] key on the remote control for more than 2 seconds to be able to select a TV
format (PAL/NTSC).
PAL NTSC
In case of using HDMI cable z
A format is automatically selected for your TV format.
During HDMI cable connection, the format of the composite video output is adjusted to the •
connected TV monitor.
B60-5815-08_01_GVT0295-001B_K-821DV_En.indb 12 B60-5815-08_01_GVT0295-001B_K-821DV_En.indb 12 10.1.25 4:56:31 PM 10.1.25 4:56:31 PM