Kenwood M-505USB-S - Manual (Page 10)

10
EN
Demonstration mode
The system is equipped with a demonstration
function (only display). When the power cable is
plugged in and
button is pressed to turn the
system on for the fi rst time, the demonstration
automatically starts. The demonstration consists of
sequential change of display and indicators showing
the operations, but the audio itself does not change.
The demonstration function can be cancelled as
follows.
To deactivate the demonstration
Press (demo) button on the unit during
demonstration.
To activate the demonstration
After turning the power on, press (demo) button on
the unit.
⁄
• The demonstration operates automatically when; a power has
failed and then recovered, or the plug of the power cable has
been pulled out while the power was on and then plugged
back in.
Switching the system on
Press , CD/USB (CD/USB), TUNER band (TUNER
band), TAPE mode (TAPE mode), AUX (AUX) button.
The standby LED will go out.
The system will switch to the last selected source or
the selected source.
Switching the system to standby mode
Press button.
Standby indicator is lit.
Basic function
Volume control
Press VOLUME UP (turn (volume) knob to the right)
button to increase, or press VOLUME DOWN (turn
(volume) knob to the left) to decrease the volume
level.
“VOL XX” is displayed. “VOL XX” denotes the volume
level.
To switch off the volume temporarily
Press MUTE button.
Playback continues without sound, and the icon
“MUTE” appears on the display.
⁄
• To restore the volume, press MUTE button again or adjust the
volume.
Sound control
The sound control system feature enables you to
enjoy special sound eff ects; preset equalizer settings
and bass enhancement, providing the best music
reproduction.
To switch on preset equalizer settings
Press EQ (EQ) button to select the desired sound
eff ect: POP, CLASSIC, ROCK, JAZZ or FLAT (off ).
To switch on the bass enhancement
Press X.BASS (X-bass) button. The icon “X-BASS”
appears on the display.
⁄
• To switch off X-BASS, press X.BASS (X-bass) button. The icon
“X-BASS” disappears.
• EQ and X-BASS functions are not applied to the recording
sound.
Headphones
To listen to your stereo with headphones (separately
available), use the 3.5 mm phones jack on the unit.
¤
• Excessive sound pressure from earphones and headphones
can cause hearing loss.
M-505USB_EN_r12.indd 10 M-505USB_EN_r12.indd 10 07.8.29 4:44:43 PM 07.8.29 4:44:43 PM