Kenwood TS-590S - Manual (Page 15)

15
The transceiver does not
transmit VOX when audio input
is from the computer
microphone.
In order to transmit VOX when voice data
input is received through the rear
terminal, specific menu settings are
required.
Refer to “4.1.4 Data VOX Settings” and
“4.1.6 Data VOX Gain Setting” and check
the settings.
Operation The end of audio transmissions
are cut off. The system switches
back to audio reception before
sending all of an audio
transmission.
When using the ARCP-590, if you quickly
switch to receive mode after using the
computer’s microphone to transmit, you
may have switched before the audio is
transmitted because of the delay in
transmitting an audio signal via USB.
If this happens, it may be possible to
avoid such delays by slightly changing the
method of operation, as described below.
・ After transmission, watch the power
and ALC meters and wait until the
audio input to the transceiver finishes
before switching back to reception
mode.
・ Use the DATA VOX function.
Use a regular stereo jack instead of a
USB or Bluetooth headset.