Kenwood TK-7180E - Manual (Page 24)

18
DTMF (DUAL TONE MULTI FREQUENCY) CALLS
M
ANUAL
D
IALING
TK-7180/ TK8180 Models: To make a DTMF call using manual dialing, you must use an optional
microphone with a DTMF keypad.
■ M
ETHOD 1
Press and hold the microphone PTT switch, then enter the desired digits
using a DTMF keypad.
• If you release the PTT switch, transmit mode will end even if the complete number
has not been sent.
• If your dealer has activated the Keypad Auto PTT function, you need not press the
PTT switch while entering digits. The DTMF code will be sent automatically when
you press a key.
■ M
ETHOD
2
Enter the desired digits using a DTMF keypad (maximum of 30 digits). After
entering the complete number, press the microphone PTT switch.
• The DTMF code is transmitted after pressing the PTT switch.
Note: Switching OFF the transceiver power clears the number.
A
UTODIAL
Autodial allows you to store and quickly recall 32 names (up to 12 characters per
name) and DTMF numbers (up to 16 digits per number).
R
EDIAL
TK-7180/ TK-8180 Models: To redial a number, you must use an optional microphone with a DTMF
keypad.
1 To redial the last called number, press the key programmed as Autodial.
• The first entry in the Autodial list appears on the display.
2 Press the DTMF key followed by the DTMF 0 key to display the last called
number.
3 Press the microphone PTT switch to make the call.
Note: Switching OFF the transceiver power clears the redial memory.