Kenwood TK-7180E - Manual (Page 16)

10
CONVENTIONAL SCAN
If the Scan function is programmed, Conventional zones or channels can be
scanned by pressing the key programmed as Scan. Scan can be used as either
Single Scan or Multi Scan.
• Single Scan monitors only the channels of the currently selected zone, which have
been added to the scanning sequence. If set up to scan Priority channels, the Priority
channels will be scanned even if they are not within the currently selected zone.
• Multi Scan monitors all channels of every zone, which have been added to the
scanning sequence.
To activate Scan, press the key programmed as Scan.
• The icon and “ ” or the revert zone and channel number appear on the display.
• The zone add indicator ( ) will appear on the display when the selected
zone is added to the scan sequence. The channel add indicator ( ) will
appear on the display when the selected channel is added to the scan sequence.
• When a call is received, scanning stops and the zone and channel digits appear.
Press the microphone PTT switch and speak into the microphone to respond to the
call. The transceiver will continue scanning after a predetermined time delay if the
PTT switch is released and no further signal is received.
To stop scanning, press the Scan key again.
A
DD TO
S
CAN
/ D
ELETE FROM
S
CAN
Press the key programmed as Scan Delete/Add to add or remove each channel
to or from the scan sequence.
• The channel add indicator ( ) will appear on the display when the
selected channel is added to the scan sequence.
Press the key programmed as Zone Delete/Add to add or remove each zone to
or from the scan sequence.
• The zone add indicator ( ) will appear on the display when the selected
zone is added to the scan sequence.