Connections – Kenwood C-515BT User Manual
Page 6
6
C-515BT/C-313
VIDEO
Connections
¤
CAUTION
Be sure to adhere to the following, or proper
ventilation will be blocked causing damage or
fi re hazard (Main unit and AC adapter).
• Do not place a cloth on the system or place it on a carpet
or cushion.
• Do not use the system in a poorly ventilated place.
• Do not place any objects impairing heat radiation onto
the top of the unit.
• Leave some space around the unit (from the largest
outside dimension including projection) equal to or
greater than, shown below.
Top panel : 50 cm
¤
CAUTION
The power in this equipment will not be completely cut off
from the wall outlet when the standby switch is turned off.
Install the equipment so that the wall outlet is easily
accessible and, in case of emergency, immediately unplug
the power plug from the wall outlet.
Mains plug is used as the disconnect device, It shall remain
readily operable and should not be obstructed during
intended use.
AM loop antenna
FM indoor antenna
iPod dock
Right speaker
Left speaker
To AC wall outlet
• Insert the plug firmly all
the way into the AC wall
outlet.
To TV with video (composite)
input terminal
Video cord
Power cord
Two types of power cords
are provided. Select the one
designed for the country in
which this unit is used.
AC adapter
Use the AC adapter (AC-
18335A) provided with this
product.
Connect the audio output of
the VCR, etc. to the [AUX IN]
terminals on the rear of the
main unit.
Connect a subwoofer (SW-40HT (separately available),
etc.) to the [SUB WOOFER PRE OUT] terminal on the rear
of the main unit.
C-515BT
B60-5807-08_02_English.indd 6
09.6.17 9:04:44 AM