Kenwood C-515BT - Manual (Page 24)

24
C-515BT/C-313
General information
Maintenance
Cleaning the cabinet
• Use a soft cloth slightly moistened with a mild detergent
solution. Do not use a solution containing alcohol, spirits,
ammonia or abrasive.
Cleaning discs
• When a disc becomes dirty, clean it with a cleaning cloth,
wipe the disc from the center out. Do not wipe in circular
motion.
• Do not use solvents such as benzene, thinner commercially
available cleaners, or antistatic spray intended for analogue
records.
Caution on condensation
Condensation (of dew) may occur inside the unit
when there is a great diff erence in temperature
between this unit and the outside. This unit may
not function properly if condensation occurs. In this
case, leave the unit for a few hours and restart the
operation after the condensation has dried up.
Be specially cautious against condensation in the
following circumstances:
When this unit is carried from one place to another
across a large diff erence in temperature, when the
humidity in the room where this unit is installed
increases, etc.
Copyright information
Materials recorded from broadcasting, CDs, discs or
other recorded materials (music tapes, karaoke tapes,
etc.) are protected by the copy right just like the
verses and melodies of songs.
The copyright law prescribes that the permission
from the copyright owners is required to sell,
distribute, transfer or lend the materials recorded
from the above recorded materials or to use them on
a commercial basis (including background music in
shops, etc.).
To install this unit and/or speakers on
a wall
Prepare commercially available woodscrews.
9 mm
16 mm
1
On a stable pillar or wall, attach a pair of
woodscrews at the same interval as the interval
between the wall-mount holes of this unit or
speaker.
Screw attaching interval
Main unit: 120mm (C-313/C-515BT)
Speaker: 90mm (C-313)
120mm (C-515BT)
4 mm
2 Fit the screws into the wall-mount holes on the
rear of the main unit or speaker.
• The heat radiation from the rear of the main unit may deform
or discolor the wall made of certain material.
Be sure to observe the following points when installing the
unit on a wall. Otherwise, the product may drop and cause
damage or an injury.
• Check the strength of the wall before installation. Do not
install on a plywood or plaster board. If you have any doubt
related to the wall strength, please consult a specialist.
• Check that the screws are fit securely into the wall-mount
holes of the main unit and/or speakers.
• Even after installation, use care so that the unit and/or
speakers do not drop due to an accidental contact, etc.
B60-5807-08_02_English.indd 24 09.6.17 9:04:51 AM