Kenwood C-515BT - Manual (Page 5)

English
5
Preparing the remote control unit
Pull the battery sheet out from the
remote control unit to the direction of
the arrow.
Operation
When the power cord is plugged in, STANDBY/TIMER
indicator is lit. The power turns ON by pressing
button on the remote control unit pointing at the
remote sensor. When the power comes on, press the
button you want to operate.
Approx. 6 m
30° 30°
Remote sensor
⁄
• The supplied battery may have shorter live than ordinary
battery due to use during operation checks.
• When the remote-controllable distance gets shorter than
before, replace the battery with a new one.
• Placing the remote sensor in direct sunlight, or in direct
light from a high frequency fluorescent lamp may cause a
malfunction.
In such a case, change the location of the system installation
to prevent malfunction.
¤ CAUTION
• Lithium battery.
Danger of explosion if the battery is incorrectly replaced.
Replace only with the same or equivalent type.
• The battery pack or batteries shall not be exposed to
excessive heat such sunshine, fire or the like.
• Keep battery out of reach of children and in original
package until ready to use. Dispose of used batteries
promptly. If swallowed contact physician immediately.
Changing the battery of the remote control
unit
Use a commercially available button battery
(CR2025).
1 Insert something narrow like a paperclip into
the hole 1 and pull out the battery tray.
Keep on slide
Pull out
2
Replace the old battery with a new one.
CR2025(+side)
How to read this manual
The description in this manual is based on the
C-515BT, and the C-313 is not equipped with the
selectors and functions related to iPod and Bluetooth.
The descriptions of the functions available only with
the C-515BT are marked with the following symbol.
C-515BT
Most of the functions are designed to be able to
operate from the remote control unit.
B60-5807-08_02_English.indd 5 09.6.17 9:04:43 AM