Kenwood MGR-E8-B User Manual

Page 36

MGR-E8

Changing the Recording Settings

Item

Setting

Setting overview

Int.
Mic

t. M

Mic Sync Rec

OFF*/ON

Recording starts in synchronism with the
start of microphone sound input. Recording
pauses when no sound has been input for
2 seconds.
This item is enabled when [MIC REC LEVEL]
is set to AUTO.

● ●

Analogue limiter OFF*/ON

When high-level sound is input suddenly
while this item is set to ON, the recording
level is automatically adjusted to prevent
distortion of the recorded audio.
This item is enabled when [MIC REC LEVEL] is
set to MANUAL.

● ●

Low-cut filter

OFF*/ON

Set to ON to reduce noise from the air
conditioner or blowing wind by cutting off
the low frequencies.

● ●

Delay Rec

OFF*/5sec/10sec/30sec

Set the delay time reserved before actual
recording starts after [REC] is pressed. This
is convenient when preparation is required
before starting recording, for example for
checking the musical instruments, etc.

● ● ●

Line auto divide

OFF*/ON

When this item is ON, recording on a new
file begins when no sound has been input for
2 seconds.

●

Auto divide level High/Mid*/Low

Set the level for detecting the beginning
of music.

●

(* : Factory setting)

• Since the and recordings start after the

start of audio is detected, the initial section of the audio may not be recorded.
To prevent this, do not use these settings for important recordings. It is
recommended to record a single file and divided it later. (page 40)

B60-5825-08_00_MGR-E8(E)_English_1AJ6P1P0109--(XE0).indd 36

10/08/04 13:48