Kenwood K-531-SB - Manual (Page 39)

39 English
Timer settings
Setting the program timer (TIMER SET)
This function allows you to use the timer to start playback or recording
automatically at a specified time. You can set two timers (“PROG. 1” and
“PROG. 2”).
The available sources for program timer are as follows:
– For playback: TUNER, CD, iPod, USB, D-IN, AUX or AUDIO-IN
– For recording: TUNER
Set the System clock to the correct time before performing this procedure. z
(P.41)
Prepare the input source and check whether it works.
z
For recording with a timer, connect a USB device (with sufficient free z
space) to the terminal. (P.30)
To go back to the previous step, press z [
2 ].
1
Press [MODE].
2
Press [
2 ] or [ 3] to select “TIMER SET”, then press [ENTER].
Continued to next page
For “AUX” or “AUDIO-IN”, connect a component equipped with a timer function. You cannot z
activate or deactivate the timer function of the connected component by operating on the System.
When recording with a timer, the System is turned on and paused 2 minutes before the start time
z
of the recording.
When you activate two programs, make sure the times for each program are different by at least 3
z
minutes to ensure that their operations do not overlap.
If you select "PLAY" or "AI PLAY", turn off the System more than 1 minute before the start time.
z
If you select "REC", turn off the System more than 3 minutes before the start time. z
When the System is in Standby mode, you can display the timer setting (on or off) and the current z
time for 5 seconds by pressing [
7
] .
K-531[E_X].indb 39 K-531[E_X].indb 39 12.8.1 11:40:13 AM 12.8.1 11:40:13 AM