Alpine IVA-D100 - Manual (Page 51)

47
-EN
01GB06IVA100.fm
ALPINE IVA-D100 68-05946Z49-A (EN)
If PL II MUSIC is selected, the center width can be adjusted with
following operations.
This function offers the optimum vocal position by adjusting the
center channel position between the center speaker and the L/R
speaker. (The adjustments established in “Adjusting the
acoustic image (BI-PHANTOM)” (page 45) are ineffective while
this function is activated.)
Touch [ ] or [ ] of CENTER WIDTH CONT to adjust the
level.
The level can be adjusted between 0 to 7. When the level
increases, the center channel position moves from the
center speaker position to both sides.
Touch [OFF] of CENTER WIDTH CONT to turn off the
center width control.
• This adjustment is effective when the setting of the center speaker is
SMALL or LARGE in the speaker setup settings.
• “REAR FILL” function
Depending on the input signals, the sound may only be output from
the front speakers. In this case, the “REAR FILL” function can be
used to output signals from the rear speakers as well.
• Avoid stopping, pausing, switching the disc, cueing, fast-forwarding
or switching the audio channel of this unit while making this
adjustment. The setting is canceled if the Decode mode is switched.
• This adjustment is ineffective when the speaker is set to CENTER
OFF in “Setting the Speakers” (page 41).
• This function only works with two-channel signals. This operation is
ineffective when 5.1-channel DTS or Dolby Digital signals are input.
• If the setting of REAR FILL is made when REAR MIX is ON, sound is
unchanged in the rear fill setting because REAR MIX is given priority
during 2 channel decoder other than linear PCM.
• For linear PCM signals, the voice is output from the rear speaker
regardless of the REAR FILL and REAR MIX setting.
• Touching [RTN] will return to the previous screen.
Linear PCM Setting
The output when playing discs recorded in linear PCM can be set to 2 or
3 channels.
1
Check that Defeat mode is off.
2
Press SETUP.
The SETUP selection screen appears.
3
Touch [ ] of i-Personalize.
The i-Personalize screen will appear.
4
Touch [ ] of A.PROCESSOR.
The A.PROC list screen appears.
5
Touch [ ] or [ ] of PCM MODE to select 2 CH or 3
CH.
• This adjustment is ineffective when the speaker is set to CENTER
OFF in “Setting the Speakers” (page 41).
Switching the Navigation Screen
(Optional)
If an optional Alpine Navigation System is connected to the IVA-D100,
the Navigation screen can be displayed on this unit.
1
Press SOURCE/POWER.
The source screen appears on the display.
2
Touch [ ] of NAV.
The Navigation screen is displayed.
The operation is possible with the supplied navigation
remote control.
For navigation operation, refer to the Owner’s Manual of the
navigator.
• While the Navigation selection mode is being selected in “Setting the
VISUAL Button” (page 36), the navigation mode will be directly
activated.
• If the Navigation mode menu is not displayed on the main menu
screen, set NAV. IN to on by following “Setting the Navigation
Mode” (page 35).
• When the Navigation System is on, the audio and visual navigation
cuts in.
• For operation, if a navigation system with touch panel operation is
connected, refer to the Owner's Manual of the navigation system.
2CH: 2ch output (L/R)
3CH: 3ch output (L/R/CENTER)
Navigation System
(Optional)
01GB00IVAD100.book Page 47 Tuesday, February 14, 2006 4:10 PM