beautypg.com

Blackout mode on and off, Setting rear camera interruption – Alpine IVA-D100 User Manual

Page 31

background image

27

-EN

01GB05IVA100.fm

ALPINE IVA-D100 68-05946Z49-A (EN)

In Mode 2 (Cinema), the monitor displays a normal picture by
stretching out the picture horizontally and vertically. This mode is
good for displaying a cinema type picture at the 16 : 9 ratio.

In Mode 3 (Normal), the monitor displays a normal picture at the
center of the screen with a vertical black band at each side.

Switching the Visual Source Only
(Simultaneous Function)

You can watch the video portion of another source while listening to the
current source.

After carrying out the steps 1 to 3 of “To display the DVD mode

Screen” explained on page 28, perform the operation described
below.

1

Press VISUAL on the unit.

The VISUAL selection screen appears.

2

Touch [

] of a desired visual source.

The visual source is switched to the selected one.
The visual indicator lights up.

1

Press VISUAL.

2

Touch [

] of NORMAL.

The simultaneous function is canceled.
The visual indicator goes out.

To apply the setting, set to VISUAL in “Setting the VISUAL Button”

(page 36).

If a DVD player is connected, you can receive the DVD picture.

DVD changer (DHA-S680) is connected:
Press and hold V.OUT on the remote control supplied with the DVD
player or DVD changer for more than 2 seconds. The picture of the
DVD will be output.
The DVA-5210 is connected:
Press V.OUT on the remote control (included with the DVA-5210) to
output DVD picture.

The simultaneous function cannot be used when the Audio source is

in the navigation mode.
When NAV. is set in “Setting the VISUAL Button” (page 36), only the
navigation screen can be recalled.

When the “Setting the AUX Mode” (page 35) is set to OFF, the

auxiliary source is not displayed.

Blackout Mode On and Off

When Blackout mode is turned on, the monitor display will turn off to
reduce power consumption.
This additional power enhances the sound quality.

1

Press VISUAL on the unit.

The VISUAL selection screen is displayed.

2

Touch [

] of OFF.

The backlit-display portion goes out.
The guide indicator blinks slowly.

3

Touch [

] of OFF again to cancel the display

backlight.

To apply the setting, set to VISUAL in “Setting the VISUAL Button”

(page 36).

If any button on the unit is pressed during Blackout mode, the

function will be displayed for 5 seconds to show the operation before
returning to Blackout mode.

While the backlighting is turned off, the guide indicator blinks during

navigation voice interruption.

Setting rear Camera Interruption

When the rear camera is connected, rear pictures are output on the
screen.

1

Select CAMERA in “Setting the AUX Mode”
(page 35).

2

Press VISUAL on the unit.

The VISUAL selection screen is displayed.

3

Touch [

] of CAMERA.

Rear picture is output even if you do not engage the shift
lever in reverse (R).

4

To cancel the setting, press VISUAL on the unit, and
touch [

] of NORMAL.

By shifting to reverse (R),the rear pictures are output. This function is

effective when the reverse wire is properly connected.

Cancelling the Simultaneous Function

01GB00IVAD100.book Page 27 Tuesday, February 14, 2006 4:10 PM