Help – Kenwood KVT-526DVD User Manual
Page 90
90
KVT-526DVD/KVT-556DVD
Some functions of this unit may be disabled by
some settings made on this unit.
!
• Cannot set up the subwoofer.
• Cannot set up subwoofer phase.
• No output from the subwoofer.
• Cannot set up the low pass filter.
• Cannot set up the high pass filter.
▲
Subwoofer is not set to On.
☞
▲
Preout is set to "Rear".
☞
▲
The Dual zone function is enabled.
☞
!
Cannot set up the subwoofer phase.
▲
Subwoofer is not set to On.
☞
▲
Low pass filter is set to Through.
☞
!
• Cannot select the output destination of the
subsource in the Dual zone.
• Cannot adjust the volume of the rear
speakers.
▲
The Dual zone function is disabled.
☞
!
Cannot play audio files.
▲
"CD Read" of
to "2".
!
Cannot Folder select.
▲
The Scan play or Random play function is
enabled.
!
Cannot perform Repeat play.
▲
The PBC function is enabled.
!
• Cannot set up the equalizer.
• Cannot set up the crossover network.
▲
The Dual zone function is enabled.
☞
!
Cannot watch the source selected as AV-OUT
in the rear monitor.
▲ A source control screen is displayed in front.
☞
▲
"AV-OUT Graphic Output" of Setup> is set to "Black". What might seem to be a malfunction in your unit General ? The Touch Sensor Tone doesn’t sound. ✔ The preout jack is being used. ☞ The Touch Sensor Tone can’t be output from the preout jack. Tuner source ? Radio reception is poor. ✔ The car antenna is not extended. ☞ Pull the antenna out all the way. ✔ The antenna control wire is not connected. ☞ Connect the wire correctly, referring to the section on Disc source ? The specified disc does not play, but another one plays instead. ✔ The specified disc is quite dirty. ☞ Clean the disc. ✔ The disc is severely scratched. ☞ Try another disc instead. Audio file source ? The sound skips when an Audio file is being played. ✔ The media is scratched or dirty. ☞ Clean the media, referring to the CD ✔ The recording condition is bad. ☞ Record the media again or use another media. Help? Troubleshooting B64-4551-00_00_E_en.indd 90 B64-4551-00_00_E_en.indd 90 09.10.27 5:14:08 PM 09.10.27 5:14:08 PM
may just be the result of slight misoperation or
miswiring. Before calling service, first check the
following table for possible problems.
cleaning of the section on
(page 4).