Actiontec electronic Wireless-Ready - Manual (Page 6)

3
Connecting
the Gateway
The instructions that follow parallel closely with the steps contained in the Installation
Buddy, which provides a visual guide to setting up the Gateway. It is recommended
that the user run the Installation Buddy first, before attempting any other procedures.
To set up the Gateway, the user must first connect it to a computer via USB or
Ethernet cable. After connecting this first computer, other computers can be added
to the home network via
USB , Ethernet, or wirelessly (see “Connecting Additional
Computers on page xx).
Connecting the Power and DSL Cable
1. Get the DSL Gateway from your DSL Quick Start Kit and take it out of the bag.
2. Get the Power Cord out of the Black Bag and plug the smaller end of the
Power Cord into the Black Port located on the back of the DSL Gateway.
4