Siemens LU19050 - Manual (Page 22)

22
Electrical connection
The mains power supply must correspond to
the rating indicated on the plate situated
inside the hood. If provided with a plug
connect the hood to a socket in compliance
with current regulations and positioned in an
accessible area. If it not fitted with a plug
(direct mains connection) or if the plug is not
located in an accessible area apply a bi-
polar switch in accordance with standards
which assures the complete disconnection of
the mains under conditions relating to over-
current category III, in accordance with
installation instructions.
Warning! Before re-connecting the hood
circuit to the mains supply and checking the
efficient function, always check that the
mains cable is correctly assembled.
Warning! Power cable replacement must be
undertaken by the authorized service
assistance centre or similar qualified person.
Connect the hood to a norm complying plug
only. The plug should be located in an
accessible zone.
❑ The plug must be equipped with a
protection circuit.
❑ If after installation the plug can not be
reached, a disconnecting device must be
envisaged.
Fixed installation:
The fixed installation can be carried out by a
qualified and authorized person only.
Envisage an omnipolar switch having a
contact opening of at least 3mm, including
an automatic circuit breaker.
The cable must be replaced by the
manufacturer, the assistance centre or a
qualified and authorized person only, in
order to avoid any dangers.
Electrical data:
The technical data of the device are on the
distinctive label inside the device behind the
grease filters.
In case of repair, disconnect the electric
supply from the cooker hood.
Length of the feeding cable: 1,30m.
The hood complies with the EMC directives.