Siemens TE803209RW - Manual (Page 17)

13
en
Water filter
A new water fi lter must be rinsed before it
can be used.
● To do this, press the water fi lter fi rmly
into the water tank 11 with the aid of the
measuring spoon 14. Fill the water tank
with water up to the “ max” mark.
● Turn the rotary knob 6 to select start
and press the start button 8.
Place 1 l container
Place suction pipe in container  start
● Place a container with a capacity of 1 litre
under the milk frother 10.
● Place the end of the suction pipe 10d in
the container.
● Press the start button 8. Water will now
fl ow through the fi lter to rinse it.
● Next, empty the container.
The appliance is ready for use again.
Info: Rinsing the fi lter simultaneously
activates the setting for the “change fi lter”
display.
You can fi nd detailed information about the
water fi lter in the enclosed fi lter instructions.
The fi lter is no longer effective when the
Service - change filter display appears,
or at the latest after two months. It needs to
be replaced for reasons of hygiene and so
that there is no build-up of limescale (this
could damage the appliance).
Replacement fi lters can be obtained from
retailers (TZ70003) or from customer
service (575491).
If no new fi lter is used, turn the Water
filter setting to no .
Info: If the appliance has not been used for
a prolonged period (for example, when you
are on vacation), the existing fi lter should
be rinsed before the appliance is used
again. To do this, simply dispense a cup of
hot water.
Transport. lock
● To avoid damage caused by frost during
transport and storage, the appliance must
be completely emptied fi rst.
Info: The appliance must be ready for use
and the water tank 11 fi lled.
● Press the start button 8. The appliance
automatically empties the pipe system
and switches off.
● Empty the water tank 11 and the drip
tray 23.
Factory reset
You can cancel your own settings and reset
the factory settings.
● To activate the factory settings, press the
start button 8.
Info: The appliance can also be reset to
the factory settings using a combination of
buttons. The appliance must be switched
off fully.
● Hold down the selection buttons < and
> 4 and the on/off switch 1 O / I at the
same time for at least 5 seconds. Press
the start button 8. The factory settings
are now reactivated.
TE803_806_1RW.indb 13 08.05.2013 14:24:10