Kenwood TK-6110 - Manual (Page 7)

3
■ Installing the Transceiver
Microphone
hanger
Microphone
Microphone cable
Mounting bracket
Antenna
connector
Transceiver
Power input
connector
Power cable
Battery
Fuse holder
Fuse
Hex headed
screw
Red wire
1 Mark the position of the holes in the dash by using the mounting bracket
as a template. Drill the holes, then attach the mounting bracket using the
supplied 5 x 16 mm screws.
• Be sure to mount the transceiver in a location where the controls will be within
easy reach of the user and where there is sufficient space at the rear of the
transceiver for cable connections.
2 Connect the antenna and the supplied power cable to the transceiver.
3 Slide the transceiver into the mounting bracket and secure it using the
supplied hex-headed screws.
4 Mount the microphone hanger, using the supplied 4 x 16 mm screws, in a
location where it will be within easy reach of the user.
• The microphone should be mounted in a place where it will not interfere with
the safe operation of the vehicle.
5 Connect the microphone cable to the jack on the front panel of the
transceiver. Place the microphone on the hanger.
FOR PASSENGER SAFETY, INSTALL THE TRANSCEIVER SECURELY, USING THE
SUPPLIED MOUNTING BRACKET, SO THE TRANSCEIVER WILL NOT BREAK LOOSE IN
THE EVENT OF A COLLISION.
Black wire