Kenwood TK-6110 - Manual (Page 17)

13
AUXILIARY FUNCTIONS
The following functions can be set up by your dealer.
■ Time-out Timer (TOT)
The TOT is used to automatically inhibit transmission after a specified time
elapses. If the PTT switch is held down for longer than the programmed time,
the transceiver will stop transmitting and a warning tone will sound. To stop
the warning tone, release the PTT switch.
■ Busy Channel Lockout (BCL)
BCL prevents you from interfering with other stations that may be using the
same channel as you. When you press the PTT switch while the channel is in
use, a warning tone sounds and the transceiver does not transmit. To stop
the warning tone, release the PTT switch.
If BCL override has been enabled, you can press the PTT switch again within
0.5 seconds to cancel BCL. The transceiver will transmit.
■ 2-Tone/ DTMF Signaling
2-Tone/ DTMF signaling will only open the squelch when the proper code is
received. When the transceiver receives a correct code, the CALL icon
flashes.
If transpond has been enabled, the transceiver automatically sends an
acknowledgement signal after receiving the 2-Tone/ DTMF signal.
If alert tone has been enabled, an alert tone sounds after receiving the
2-Tone/ DTMF signal.
■ Roll Over/ Dead End
If roll over is enabled and you are pressing the Channel Up and Channel
Down keys, when you reach the maximum or minimum number, the number
will roll over to the minimum or maximum number. For example, when the
pressing the Channel Up key, the channel number increases. When it
reaches its maximum value, it rolls over to its minimum value and then starts
to increase again.
If dead end is selected, when you reach the maximum or minimum value, the
value will not change. For example, when when the pressing the Channel
Up key, the channel number increases. When it reaches its maximum value,
it stops. You must then press the Channel Down key to change the value.