Kenwood RC-D710 - Manual (Page 38)

32
AUX 2 (RC-D710 + PG-5J)
Menu
No.
Display Description
Setting
Values
Default
Setting
999 RESET Reset
PM RESET/
FULL RESET
PM RESET
1 Available only when the optional VGS-1 unit is installed in the TM-V71(A/E).
2 Available only for TM-V71(A) K type models.
3 Available only for TM-V71(A/E) K and E types models.
4 Available only for TM-V71(E) {version 2.1 later}.
Note: The default settings are subject to change.
CHARACTER ENTRY
Certain menus require you to enter characters, such as the power on message
and memory names. When character entry is required, a cursor will appear on
the display.
1 Press
the Tuning control.
• The cursor will blink.
2 Rotate the Tuning control to select your desired character.
3 Press the Tuning control to set the selected character.
• The cursor will move to the next digit.
• You can move the cursor to the left or right by pressing [ ←] or [→].
• You can insert one space by pressing [SPACE].
• You can insert a character by pressing [INS].
• You can delete the selected character by pressing [CLR].
4 Repeat steps 2 and 3 to enter the remaining characters.
• Press [ESC] at any time to exit Menu mode.
• Press [BACK] at any time to cancel the Menu setup and return to the Menu
selection.