Hot Max Torches 175WFG - Manual (Page 19)

KDAR Company 18
Troubleshooting
Problem
Arc is unstable—Poor starting
Possible Cause
1. Check to insure proper input voltage to the weld-
er. Check the plug to make sure the unit was
wired correctly for 230V.
2. Check electrode polarity to make sure it is cor-
rect for the process being used.
3. Check tip for proper size and damage; replace if
necessary.
4. Insure proper gas flow for the process.
5. Make sure the connections for the ground cable
are correct.
6. Make sure the drive roll is installed and aligned
properly.
7. Make sure the wire size is correct and there is no
damage to the gun cable assembly.
Note: For problems that can not be corrected by following the troubleshooting proce-
dures listed above; please contact KDAR Company. NEVER attempt to work on any part
of the welder not listed above. Unauthorized repairs to the unit may result in danger to
the operator and will void the factory warranty.