Hot Max Torches 175WFG - Manual (Page 10)

Installation/Setup
KDAR Company 9
Input Connections
The 175WFG welder has power input cables located on the rear of the unit. A plug for the cord is not included
and must be purchased separately. Follow the directions provided with the plug for terminating the power
cable located on the back of the machine. Make sure the plug you purchase is rated for 250 Volts and 50
Amps minimum.
Gas Hook Up (cont.)
7. Reopen the regulator valve until the flow indicator shows
15 L/min (initial flow setting). The setting may need to be
adjusted by the operator to compensate for welding condi-
tions.
8. Always close the cylinder valve and open the regulator
valve when not in use.