Dake Model Super Technics 350CE - Manual (Page 5)

5
350 SUPER TECHNICS 350 SUPER TECHNICS 350 SUPER TECHNICS 350 SUPER TECHNICS 350 SUPER TECHNICS
TECHNICAL
CHARACTERISTICS
3.1 - Table of cutting capacity and technical details
4.2 - Transport and handling of the machine
If the machine has to be shifted in its own packing, use a fork-lift
truck or sling it with straps as illustrated.
remove the part and check that the disk or its teeth are not
broken. If they are broken, change the tool.
- Before carrying out any repairs on the machine, consult the
dealer or apply to THOMAS.
3
CAPACITA` DI
TAGLIO
90° 85 120 105x105 160x90
45° DX - SX 75 100 85x85 85x70
180° 0 - 100
CUTTING
CAPACITY
4
1150
1380 530 420
950
1910 WITH
PEDEST
AL
4.3 - Minimum requirements for the premises
housing the machine
- Mains voltage and frequency complying with the machine motor
characteristics.
- Environment temperature from -10 °C to +50 °C.
- Relative humidity not over 90%.
4.4 - Anchoring the machine
- Three-phase el. motor for 3-speed disk
rotation kW 1.35ч1.7ч2.4
- Single-phase el. motor for 1-speed disk
rotation kW 2.2
- Reduction gear in an oil bath Ratio = 1 : 32
- Maximum disk diameter mm 350
- Disk rotation speed rpm 22ч44ч88
- Vice opening mm 170
- Machine weight kg 186
MACHINE DIMENSIONS
TRANSPORT
INSTALLATION
DISMANTLING
4.1 - Machine dimensions
PEDESTAL PROFILE
SEC. A - A
M8
70 550 70
690
A A
445
185
630
- Position the machine on a firm cement floor, maintaining, at
the rear, a minimum distance of 800 mm from the wall; anchor
it to the ground as shown in the diagram, using screws and
expansion plugs or tie rods sunk in cement, ensuring that it is
sitting level.
12