Summers 30' Superroller - Manual (Page 14)

SECTION 2 - ASSEMBLY
1
1
2
2
A A
B B
-20 3/15/2007 9LR3042.iam/
WINGS SHOULD BE POSITIONED SO SCRAPERS WILL BE TOWARDS THE REAR OF LANDROLLER
2-4
MF2. Position 8P6115L as shown in the drawing below. 8P6115L weighs 1166 lbs, use extreme
caution when positioning 8P6115L. Pay particular attention to the drawing to ensure that the
proper wing is installed on the appropriate side. When positioned properly as shown in figure
the correct orientation of the wing is determined by the mud scraper. The mud scraper should
be positioned towards the rear of the machine as show in figure below.
MF3. Install 2 8P3910 pins into the mating holes on the Main Frame. At this point the wing will be
free to pivot. Block wings after the pins have been installed to control unexpected move-
ment.
Figure 1