Videoswitch Vi-K3 - Manual (Page 63)

Vi-K2/Vi-K3 Universal
Keyboard
Vi-K2 Universal Keyboard User Manual
61
15.7.3 Clearing a Preset
• Press and hold the ALT key and then press the STORE key.
• The display will show the letter “P—”, flashing.
• Press one of the number keys 1, 2, 3…16 to select a preset.
• Press and hold the ALT key and then press the WIPE key to clear the preset.
15.8 Tours
15.8.1 Running a Tour
• Press
the
TOUR key.
• The display will show the letter “t—”.
• Press one of the number keys 1, 2, 3, 4, 5, 9, or 10 to run a tour (sequence) that has previously
been stored.
• 1, 2, 4, 5 are tours using selected presets (see Programming a preset).
• Tour 3 is a tour of randomly selected presets.
• Tour 9 & Tour 10 are pre-recorded “Walk Patrols” (see Programming a Tour).
• The dome will run the tour until the TOUR key is pressed again.
15.8.2 Programming a Tour (Walk Patrol)
To start the tour programming:
• Holding
the
ALT key on, press the PROG key.
• The display will show the letter “t—”, flashing.
• Press one of the number keys 9 or 10 to select a tour number.
• Holding
the
ALT key on, press the PROG key.
• The display shows flashing “rEC”.
• All joystick movements will be recorded until the programming is finished.
• While the display shows flashing “rEC”, pressing one of the number keys 1, 2, 3…16 will move to
a preset (See “Presets” above).
To finish programming a tour:
• Holding
the
ALT key on, press the PROG key to finish the tour programming.
15.9 Privacy
Zones on
• Press and hold ALT then press the F12 key.
Zones off
• Press and hold ALT then press the F13 key.
Cursor toggle