Videoswitch Vi-K3 - Manual (Page 17)

Vi-K2/Vi-K3 Universal
Keyboard
Vi-K2 Universal Keyboard User Manual
15
3 Vi-K3 Configuration
3.1 Quick Configuration
This section describes how to set-up the Vi-K3 for use with any one type of dome. For more complex
configurations, see section 3.2.
• Holding
the
ALT key on, press the CONFIG key.
• The LCD display will show “Password”, indicating that a password must be entered.
• Press the number keys 1, 2, 3, 4, 5, 6 (to enter default password).
• Press
the
OK key
• Use
the LEFT and RIGHT keys to select the required protocol
• Holding
the
ALT key on, press the CONFIG key to save the configuration
The Vi-K3 is now ready to control all domes connected to the “
DOMES-1” output and a Digital Recorder
connected to the “
Out” output.
3.2 Full Configuration
3.2.1 Restore Factory Configuration
If you wish to return all settings to the factory defaults, follow this procedure:
• Power on the Vi-K3 while pressing the ALT key. Keep pressing the ALT key (for about 10 seconds)
until the word “
Store” is displayed on the LCD display.
• The Vi-K3 now has all factory settings restored.
3.2.2 Entering Menu
• Holding
the
ALT key on, press the CONFIG key.
• The LCD display will show “Password”, indicating that a password must be entered.
• Press the number keys 1, 2, 3, 4, 5, 6 (to enter default password).
• Press
the
OK key
3.2.3 Configuration
The V-K3 can now be configured using the following keys:
• UP and DOWN keys -
select configuration item to be set
• INC and DEC keys
- select auxillary parameter to be set
• LEFT and RIGHT keys
- change setting
3.2.4 Exiting Menu
• To exit the menu, holdthe ALT key on, then press the CONFIG key.