Hawkeye Roadside - Manual (Page 2)

Hawkeye Industries Inc. 2
6.)
Remove the tape from the open reel and pull out the 3 revolutions of
loose cable (approximately 5ft)
PULL OUT THE 3 REVOLUTIONS
OF LOOSE CABLE
Pass the cable over the indicator cable pulley and through the hole in the
top bracket of the indicator guide assembly. Feed the cable through the
center hole of the indicator.
7.)
With slight tension on the cable to keep the float barely off the tank floor,
slide the indicator over the cable to the minimum level on the gauge
board.
SLIGHT TENSION TO KEEP FLOAT
BARELY ON TANK FLOOR
SLIDE INDICATOR TO THE MINIUMUM
LEVEL ON THE GAUGEBOARD
8.)
Tighten the indicator set screw. Cut off the excess cable.
CUT OFF EXCESS
TIGHTEN THUMB SCREW
9.)
►
►
Roadside Installaton Complete
Proceed to Goshawk Installation (if required)
►