AMETEK 1995B Micro-Set PLS with Brake Monitor - Manual (Page 16)

Chapter 3: Programming
Installation and Maintenance Manual 12
3.14: Power-Up in a Position or RPM
The 1995B can power up displaying either Position or RPM data.
The power-up mode is programmed by entering the following:
A) Unit must be in the “Program” mode.
B) Depress . If a zero (0) is entered, ENT CIR# - 1 - 6 3 - - (0 or 1) - ENT -
positional data will be displayed upon power-up; if a one (1) is entered, the unit will power up
displaying RPM.
3.15: Decimal Point Programming
A continuous, nonfloating decimal point may be programmed on the display. If a scale factor is selected
that needs a decimal point in order to properly display its resolution in engineering units, the following 50
series codes are used:
50 - No decimal point;
clears existing decimal point 123
51 - Tenths 12.3
52 - Hundreths 1.23
To program a decimal point, enter the following:
A) Unit must be in the “Program” mode.
B) Depress .
Example: CIR# 50 = 123
CIR# 51 = 12.3
CIR# 52 = 1.23
ENT CIR# - 50 or 51 52 or -