AMETEK 7100 Leak Detect Stik - Manual (Page 2)

2
The 7100 Stik Liquid Level Sensor takes field proven
magnetostrictive sensing technology and packages it
in a revolutionary new way for greater reliability and
for easy installation and mounting. It is ideal for liquid
level monitoring of product level, interface level and leak
detection in a wide variety of liquid media in both above
ground and below ground storage tanks.
Specifications
Input Voltage 16 to 31 VDC
Sensor Length
Stainless Steel up to 24’
PVDF up to 50’
Enclosure Rating Material 316 SS or PVDF, IP 68
Typical Level Resolution
(Controller Dependent)
0.010” Inventory Mode
0.001” Leak Detection Mode
Linearity
+/- 0.01% of Full Scale
+/- 0.010”, whichever is greater
Repeatability
+/- 0.001% of Full Scale
+/- 0.00025”, whichever is greater
Temperature Measurement Up to 5 along the sensor span
Temperature Accuracy, Absolute +/- 2°F
Typical Temperature Resolution
(Controller Dependent)
+/- 0.01°F
Temperature Sensing Range - 40°F to +158°F or -40°C to 70°C
Operating Temperature Range - 40°F to +158°F or -40°C to 70°C
Sensor Output Pulse Position Modulated
Distance to Monitor Over 1000’ using twisted pair wire
Floats (not included) Specs based on 4” standard floats
Approvals
NORTH AMERICA
CLASS I,II,III, DIVISION 1,
GROUPS D,E,F,G: T4 (7100 K&V)
GROUPS C,D,E,F,G,: T4 (7100 M&R)
Exia SECURITE INTRINSEQUE
EUROPEAN UNION IEC
CE 0575
II 1 G
Ex ia IIA T4 Ga (7100 K&V)
Ex ia IIB T4 Ga (7100 M&R)
IECEx UL 11.0041X
DEMKO 09 ATEX 0902049X
Specifications are subject to change without notice. Patented.
Proven Magnetostrictive Sensing Performance in a Revolutionary New Package
All The Electronics Are Down The Tube
7100 Leak Detect Stik™ Data Sheet
All sensor electronics are SMT components integrated
into the 5/8” diameter sensing tube. Sensors are available
in stainless steel or flexible PVDF housings. The stainless
steel version has either a mini connector or a right angle
conduit fitting. The flexible PVDF version is available with
a threaded fitting and a 2’ cable (see dimensional drawing
on reverse side for connector details).
This breakthrough in package design eliminates the bulky
electronics enclosure at the top of the sensor and offers
you greater options for insertion and mounting in tanks
and vessels. In addition, standard float packages are
available which allow sensor insertion into tank openings
as small as two inches.
The 316 stainless steel version is a totally welded
construction, and has a cathodic protection boot for use
in a wide variety of applications. The Flex-Stik™ version
employs a flexible housing and provides cost effective
level monitoring in deep tanks.
The all SMT electronics have PPM (Pulse Position
Modulated) outputs for product and interface level and for
temperature measurement, which are all superimposed
on the two wire power line. All units are Intrinsically Safe
and approved for use in hazardous locations.
The 7100 Liquid Level Sensor’s inherently lower
cost design provides more options, offers savings
on installation and mounting and has the ultimate in
“designed-in” reliability.
LISTED
14X7