ARI Armaturen STOBU PN63-160 EN - Manual (Page 18)

Page 2-18 Rev. 0040102002 0213
Operating and installation instructions
STOBU
®
PN63-160
12.0 Declaration of Conformity / Declaration of Incorporation
Translated Declaration of Incorporation for partly completed machinery
according to EC Directive 2006/42/EC on Machinery
for the products mentioned above:
As the manufacturer, ARI-Armaturen GmbH & Co. KG hereby declares that the products mentioned above comply with the following
basic requirements of the Machinery Directive (2006/42/EC).
Annex I, Clauses 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.3.1, 1.3.2, 1.3.4, 1.3.7, 1.3.9, 1.5.1, 1.5.3, 1.5.4, 1.5.5, 1.5.6, 1.5.7, 1.5.15, 1.6.1,
1.7.1, 1.7.2, 1.7.3, 1.7.4
The following harmonised standards were used:
The manufacturer undertakes to submit in electronic form the relevant documentation of the partly completed machinery in response
to a duly reasoned request by the competent national authorities. The special technical documentation associated with the machine
has been drawn up in accordance with Annex VII Part B.
Authorised representative for the technical documentation: Heinrich Kramig
Schloß Holte-Stukenbrock, 28.02.2013
The declaration certifies compliance with the stated Directive; it does not, however, represent any assurance of features in the sense of product liability legis-
lation. The safety information in the supplied product documentation must be observed. This declaration is invalidated if modifications that the manufacturer
did not authorize are made to the device or if the safety information is not complied with.
Declaration of Conformity
according to Directive 97/23/EC on Pressure Equipment
We,
ARI-Armaturen Albert Richter GmbH & Co. KG,
Mergelheide 56-60, D-33756 Schloß Holte-Stukenbrock
hereby declare that the products listed below comply with the following requirements.
Description of valve series:
Stop valve with gland seal ARI-STOBU
®
Type
Nominal
pressure Nominal
diamter
Fluid group Module
Certificate-
No.:
Applied standards
005 PN 63-160 DN 32 - 100 I H
--
DIN EN 12516-2
AD 2000
leaflet A4
(1.0619+N, 1.0460, 1.5415,
1.7335, 1.7557)
006 PN 63-160 DN 32 - 100 I H
Note:
According to the above mentioned Directive 97/23/EC on Pressure Equipment (article 3, paragraph 3) products in
DN 10-25 are executed and classified acc. to „Sound engineering practice“. These products are not covered to the
requiements of the Pressure Equipment directive and need not to carry a CE mark.
Name and address of the notified licensing and monitoring agency:
Lloyd’s Register Quality Assurance GmbH
Am Sandtorkai 41, D-20457 Hamburg
Number of the named agency
0525
DIN EN ISO 12100: 03/2011
ARI products are specified for assembly with electrical, pneumatic and hydraulic actuators. Commissioning must not be carried out
until it has been ensured that the entire machine into which the ARI products are to be installed complies with the stipulations of EC
Directive 2006/42/EC.
(Brechmann, Managing Director)
..............................................