HighPoint RocketRAID 1720 - Manual (Page 28)

RocketRAID 1720 Driver and Software Installation
4 -
2. In the popup window, select Hardware tab and then click Device Manager
button.
Double click the “SCSI and RAID controllers” entry. If the RocketRAID 1720 device
entry is not displayed, or there are “?” or “!” marks displayed near the RocketRAID
1720 entry, the driver has not been installed properly. Delete the entries and reinstall
the driver.
1 - Installing the RAID Management Console/ Interface
Overview
To install the RAID software, locate the setup.exe file located on the floppy diskette
labeled “DISK 1” (or the Disk1 folder, if the software was downloaded). Double click
this file to start the Installation Wizard.
There is no need to restart the system after installing the software. To start the
software, click on the “Start” button, select “Programs”, and click on the “HPT
Management Console.”
Logging On
The RAID Management Console requires that a user (or Administrator) log on. The
software is incapable of working with RAID arrays or hard disks attached to the
RocketRAID 1720 until the user has logged on.
6