HighPoint RocketRAID 2302 User Manual
Page 75
FreeBSD Driver Support
6.
Type in “boot” and continue with installation as normal. Refer to FreeBSD
installation guide for additional information.
ok boot
Note: On some systems, when ACPI is enabled, FreeBSD may not function
properly. Try disabling ACPI in the motherboard’s BIOS settings, or type the
command “set hint.acpi.0.disabled=”1”” under the boot prompt, in order to
solve the problem.
7.
Before exiting installation, an additional step must be taken to copy the
RocketRAID driver module to the system. On the driver diskette, there is a setup
script labeled “postinstall”, which will complete this task. Before rebooting the
system, press Alt-F4 to enter the command shell, and type the following
commands:
# mount –o ro /dev/fd0 /mnt
# sh /mnt/postinstall
# umount /mnt
Then, press Alt-F1 to return to the setup screen, and choose [X Exit
Install] to finish setup.
2 - Installing the RocketRAID 230x Driver on an Exist-
ing System
If you are currently running FreeBSD and would like to access drives or arrays
attached to the RocketRAID host adapter, follow the steps outlined below:
Step 1 Copy the Driver Module
If you have made FreeBSD drivers into a diskette, you can insert the driver diskette to
floppy drive, then using the following commands to copy the driver module:
For FreeBSD 4.x:
# mount –o ro /dev/fd0 /mnt
6-4