Vaisala MMT330 - Manual (Page 104)

User's Guide _______________________________________________________________________
102 __________________________________________________________________ M210733EN-G
Date and Time
Using Display/Keypad
If the optional Data Logger Module is installed, you can change the time
and date using the display/keypad.
1. Press any of the arrow buttons to open the Main Menu.
2. Select System
and press the ►arrow button to confirm your
selection.
3. Select Date and time
and press the ►arrow button.
4. Press the SET button to enter the adjustment mode, and use the
arrow buttons to select and change the values.
5. You can also change the date and time formats that are shown in
the graphs. The selected formats are only used in graphical display,
they do not change the formats that are used in the serial
communication.
6. Press EXIT to return to the basic display.
Using Serial Line
To set time enter the TIME command. To set date enter the DATE
command.
TIME
DATE
These time and date settings are shown on the timestamps of PLAY
command. When you want to include time and date in the R and SEND
commands, use the FTIME and FDATE commands.
Example:
>time
Time : 13:42:49 ?
>date
Date : 2007-05-31 ?
NOTE If the optional Data Logger Module is not installed, time and date
available on the serial ports (only) are cleared to 2000-01-01 00:00:00 at
reset or at power failure.