Vaisala MMT330 - Manual (Page 103)

Chapter 4 _________________________________________________________________ Operation
VAISALA _______________________________________________________________________ 101
OK
>send
Oil ppm= 16.6 ppm
>
Command 'FORM /' will return the default output format. The default
output format depends on the device configuration.
>form /
OK
>send
aw= 0.087 T= 24.0 'C
>
UNIT
Use the UNIT command to select metric or non-metric output units:
UNIT [x]
where
x = M or N
where
M = Metric units
N = Non-metric units
NOTE This command changes both the serial output and display units to either
metric or non-metric units. When you want to output both metric and
non-metric units simultaneously on the serial line and display, select the
display units later by using the display/keypad.