Vaisala PTU200MIK1 - Manual (Page 10)

U SER ' S G UIDE _______________________________________________________________________
8 ___________________________________________________________________ N OVEMBER 2001
Connections in the transmitter box
1.Mount the PTU200 transmitter
on the back plate of the
transmitter box and attach it with
the four Allen screws.
2.Thread the cables through the
holes of the box and the gasket
body.
Allen key
for opening
the
transmitter
3.Thread the cables through the hole in the
bottom of the box. (The diameter of the
bottom hole is 35 mm)
4.Thread the cables through the different
parts of the gasket fitting in the order
shown in the figure. Take care that the
positions of the parts are correct.
There are two alternative rubber sealings,
one for the cables of 4 and 6 mm and one
for the cables of 6 and 6 mm.
Press the cable through the vertical cutting
of the rubber sealing.
5.After threading the cables, press the
gasket to the fitting body in the bottom of
the box and tighten the nut.