6 selecting the probe type, Selecting the probe type – Vaisala HMP46 User Manual
Page 40

HMI41 AND PROBES
Operating Manual
M210316EN-A
36
8.6
Selecting the probe type
set
If necessary, change the setting with buttons ▲ and ▼. You have now
completed the setup procedure; turn your indicator off.
NOTE
The HMI41 setup contains further settings (start, baud,
seri and calib) that appear after probe type setting when
pressing ENTER. Start setting is changed only when
using the HMP44/44L probes (
START
5, see the HM44
Operating Manual). For calib, see Chapter 5. Other
settings are meant for the HMI41 used as a field
calibrator for other Vaisala humidity transmitters. It is
recommended that these settings are not changed.