Maxsa Innovations Battery-Powered Motion-Activated LED Outdoor Wall Sconce in Golden Copper User Manual

Page 2

page 2

Note: If your

LED Outdoor Wall Sconce does not turn on after

battery installation:

•

Make sure the batteries have been inserted matching the
correct + / - polarity orientation and are making secure
contact with the terminals.

•

Make sure you are testing the

LED Outdoor Wall Sconce in

a dark area since the light will only turn on at night.

Note: Dispose of old batteries properly, following your local and

state regulations. Do not dispose of batteries in regular
household refuse or into a fire.

The selected location should not be near light sources such as
street or porch lighting as these may cause the

LED Outdoor Wall

Sconce to turn off automatically. The LED Outdoor Wall Sconce
should also be installed away from heaters, air conditioners,
barbecues, vents, and large reflective surfaces such as swim-
ming pools and jacuzzis, and white walls.

You should also install the

LED Outdoor Wall Sconce at least 30

feet away from the street since passing cars might activate the
light.

Ideally, the

LED Outdoor Wall Sconce should be mounted with

the detector at the height of or above the objects to be detected.
The motion sensor has a detection area of about 20 feet (6.5
meters) within a 90 degree angle of the sensor. The sensor is
more sensitive to movement across the detection area than
movement directly towards or away from the sensor.
At night, the LED lights will remain on for approximately 30
seconds after the last detected movement. If a movement is
detected while the lights are on, the light duration will be reset
and remain on for an additional 30 seconds (approximately).

The included mounting bracket and screws can be used to
mount the LED Outdoor Wall Sconce securely to a wall.
To install the mounting bracket:
1. Remove the mounting bracket from the back of the base by

unscrewing the two thumb screws on the front of the base.

2. Align the mounting bracket on the wall and mark the

locations of the two holes to be drilled with a pencil.
Remove the mounting bracket from the wall.

3. Drill pilot holes for screws. Screw anchors should be used

for cement, brick, or similar surfaces.

4. Align the mounting bracket on the wall and install the two

screws using a screwdriver.

1. Align the

LED Outdoor Wall Sconce on the mounting

bracket so that the two bolts go through the two holes on
the front of the base.

2. Reinstall the two thumb screws on the front of the base and

tighten securely.

Your LED Outdoor Wall Sconce is
equipped with an energy-saving
switch, located on the right side of
the sconce. The switch controls
the power output for the sconce.
Choose 100% Brightness setting
for full brightness, or 50%
Brightness setting to conserve
battery power.

BATTERY INSTALLATION (CONTINUED)

CHOOSING A LOCATION

INSTALLING THE MOUNTING BRACKET

MOUNTING THE LIGHT

USING THE ENERGY SAVING SWITCH

30 feet or more from street

Degrees

feet

Direction of

Movement

CHOOSING A LOCATION, CONTINUED