Maxsa Innovations Battery-Powered Motion-Activated LED Outdoor Wall Sconce in Golden Copper - Manual

The LED Outdoor Wall Sconce is perfect for porches, doorways,
or around the house.
The LED Outdoor Wall Sconce has a built-in motion sensor,
which automatically turns on the light when movement of a heat
source (such as people, animals, or cars) is detected in the area.
The light remains on while motion continues to be detected in
the area.
The
LED Outdoor Wall Sconce also has a built-in photosensor so
that the light only turns on at night.
The
LED Outdoor Wall Sconce may function irregularly or not at
all at temperatures below 0° F / -17.8° C. Normal operation will
return when the temperature rises.
The batteries typically last up to 1 year under normal operation.
The 2 super bright SMT LEDs in the
LED Outdoor Wall Sconce
have an estimated life of 30,000 hours, so they should never
need changing.
The
LED Outdoor Wall Sconce requires 4 C cell batteries (not
included).
1. To access the battery compartment, remove the 2 thumb
screws from the top cover. Remove the top cover.
2. Remove the battery compartment cover by squeezing the two
tabs on the opposite sides of the cover inward and pulling up.
3. Install the 4 C cell batteries in the proper +/- polarity orienta-
tion as shown in the illustration above. The positive ends of the
batteries should face the low battery contacts and the negative
ends of the battteries should face the elevated spring terminals
in the battery compartment. If your unit includes a clear rubber
spacer between the two halves of the battery compartment,
please reinsert it between the two halves.
4. Reinstall the battery compartment cover by aligning the tabs
and pressing the battery compartment cover down until the
battery compartment cover clicks into place. Once the compart-
ment is closed, the light should activate to show that power is
getting to the SMT LEDs.
5. Reassemble the LED Outdoor Wall Sconce by replacing the top
cover and reinstalling the two thumb screws. Tighten the
thumb screws by hand as tightly as possible to ensure a
waterproof seal.
ABOUT YOUR LED OUTDOOR WALL SCONCE
BATTERY INSTALLATION
BATTERY INSTALLATION (CONTINUED)
page 1
Model #44219
ASSEMBLY AND INSTRUCTION GUIDE
Thumb Screw
Battery Compartment Cover
4 C Batteries
Squeeze tabs inward
Insert 4 C batteries
in the proper +/
-
orientation