Maxsa Innovations Dual Head Solar LED Spotlight - Manual (Page 2)

HOW TO INSTALL
Your Motion-Activated Dual Head LED Security
Light works best when installed with the round
motion sensor at the bottom. To install the light
onto a solid surface, remove the screws on the
top and bottom of the back section and slide the
plastic end piece off the light.
Mount the back piece using the 2 supplied
screws (and the wall hangers if needed) utilizing
the two mounting holes in the piece.
After the end piece is secured, slide the main
body of your light back onto the end piece and
replace the two screws holding it in place.
Be sure that a power source is within range of
the 15 foot power cord as the light will not func-
tion if it does not receive power from the solar
panel. (There are extension cords available if
you need more than 15 feet to go from the solar
panel to the light . See end of instructions).
Choose a location that receives plenty of sun.
Ideally 6-8 hours of sunlight per day is required
to fully recharge your security light. The solar
panel should be facing south to get the most
sunlight.
Placing the solar panel in a shaded location will
not allow the batteries to charge fully. This will
reduce the number of hours when the Solar
Security Light will operate per evening.
In choosing a location for your Solar Security
Light, ensure that the solar panel is not placed
near nighttime light sources such as porch light
or street lighting.
The solar panel can be mounted vertically or
horizontally onto a solid surface using the sup-
plied wood/sheet metal screws and anchors.
You can adjust the angle of the solar cell by
moving the angle adjustment on the solar panel
to different locking positions. Remember it is
best to face the panel south for direct sunlight
exposure.
COLD WEATHER
In temperatures below 20ºF, the Solar Powered
Motion-Activated Dual Head LED Security Light
may not work as well. Normal performance will
return when the temperature rises.
SAFETY TIPS
Do not cut the power wire. Discontinue use if the
wire becomes frayed or broken.
Do not immerse the Motion-Activated Dual Head
LED Security Light in water or other liquid.
Position the cord from the solar panel to the light
so that it is securely fastened and will not move
around or cause someone to trip over the cord.
MAINTENANCE TIPS
The LED lights in your Motion-Activated Dual
Head LED Security Light will last up to 30,000
hours and should never need replacement.
The batteries will last approximately 3 years.
The batteries can be accessed after removing
themounting bracket. The battery we use are 3
pieces 1.2V Ni-MH 2200 mAh AA sized
rechargeable batteries.
To keep your Motion-Activated Dual Head LED
Security Light looking new, keep the lens free of
dust and deposits by wiping occasionally with a
dry cloth or with warm soapy water.
STORAGE
INSTALLING THE LIGHT
Page 2