Maxsa Innovations Solar-Powered 100 LED Motion-Activated Outdoor Security Floodlight - Manual (Page 4)

4
tools requIred For Install
install simply with just a Phillips-head screwdriver!
beFore FIrst use oF your solar securIty lIght
1. ensure the power switch on the main body of your security light is in the
off position. in this position, the solar panel will charge the battery without
activating the unit.
2. leave the switch in the off position for 3 days with the solar panel placed
in direct sunlight. this will ensure that the battery in your solar security light
has a full charge prior to motion sensor adjustment and normal operation.
operatIng your solar securIty lIght
after the initial 3 day charge of your solar security light, move the switch on the
main body to the auto position. your solar security light is now ready for use.
underneath the motion sensor, there are 3 adjustment dials: tiMe/sens/luX.
the light has been factory preset as follows:
tiMe - set at 30 seconds.
sens - set at a 10 - 15 foot range (when the surrounding temperature is 75 f).
luX - set for your security light to activate at dusk when motion is detected.
if the above settings are not suitable for your application, then these may be
adjusted using the steps below.
tIme perIod adjustment (tIme)
the time period control dial sets the duration of the light upon each activation that
the solar security light will remain illuminated after the last detected motion. the
time period has an adjustable range of 10 seconds to 1 minute.
to decrease the time period, move the dial toward the ( – ) symbol.
to increase the time period, move the dial toward the ( + ) symbol.
test the time period by triggering the motion sensor and measure the time period
the light stays on. adjust the tiMe control until the desired illumination duration is
reached.
a shorter tiMe setting will conserve battery life. for best results, use the shortest
tiMe setting for your location as possible.