Pure DTM-300 - User Guide - Manual (Page 8)

Gr
eat Britain
6
Alphanumeric Displays all stations in alphanumeric order.
Multiplex Lists stations in groups according to their multiplex.
Multiplexes are groups of stations owned and broadcast by a
multiplex operator.
Trim stn. list Removes inactive stations from the station list. Inactive
stations are those on your station list but not currently
available, marked with a ’?’.
Fav station Displays your most listened to stations at the top of the
station list and the others below. Your favourite stations are
selected by how long you listen to each station and indicated
by a
♥
next to the name in the station list.
♥
presets Available only when Favourite station order (above) has
been selected. Transfers your favourite stations to presets
overwriting any presets currently stored.
Autotune
Update your DAB station list using this option. Scans the full range of digital
frequencies in Band III and adds any new stations found to the station list.
You may want to do this if you move the unit.
Manual tune
Manually tune to new DAB stations or fine tune your reception using this
option.
You see a list of channels and frequencies. Each multiplex has a different
channel and frequency (E.g., BBC is channel 12B and Digital One is 11D).
1. Select the channel you want from the list.
You see a signal strength display. The marker indicates the minimum
required level for reception and the filled blocks indicate the current
level.
2. Move your aerial and try to raise the current level to the marker or
beyond. You see the multiplex name if a good signal is received and the
stations in that multiplex are added to the station list.
DRC Value
Make the quieter sounds in a broadcast easier to hear at low volume or in
a noisy environment using this option. The DRC (Dynamic Range Control)
level of a broadcast is set by the station and sent with the signal. At the time
of writing only stations such as BBC Radio 3 and 4 regularly broadcast a
DRC level. Check with the broadcasters to find out if they use DRC on their
stations.
Select one of the following options:
DRC off DRC is switched off. Any DRC level broadcast is ignored. This is
the default setting.
DRC half DRC level is set to half that sent with the broadcast.
DRC full Applies the DRC level as sent with the broadcast.