Pure DTM-300 - User Guide - Manual (Page 12)

Gr
eat Britain
10
Push the menu button and use +/- and SELECT to choose the Clock settings option
to view and set the time, a timer or an alarm. Choose one of the following options:
Set time
The current time is shown on the top line of the display. Press SELECT and the
+/- buttons to change the hour (24 hour clock) and minutes.
Press the TIME button on the remote at any time to see the clock.
Set alarm
The current settings are shown on the top line of the display. Press SELECT to
change the alarm settings:
Press the +/- and SELECT buttons to set an alarm time, mode [DAB/FM/CD]
and set the alarm on or off. DAB or FM alarms tune to the last station you
were tuned to. CD alarms play the CD from the first track.
Note If no CD is inserted, or the station you selected is unavailable at the
time an alarm is due to go off it will not work.
When the alarm is set you see the Alarm icon ( ) on the screen. The alarm
icon flashes when the alarm goes off.
To cancel the alarm and leave the unit switched on press SELECT or press the
Power button to cancel the alarm and switch off.
Note Alarm volume will be whatever the current volume is set to or whatever
the volume was set to when you last had your unit switched on.
Note Alarm time uses the clock you set as described above so ensure you set
this correctly before setting an alarm.
Sleep timer
The current setting is shown on the top line of the display. Press SELECT and
the +/- buttons to change the time after which you want your DTM-300 to
switch off. Choose between 15, 30, 45, 60, 1 hour 30 minutes and 2 hours
and push SELECT to confirm. To switch the sleep timer off, set the time to
zero.
You see the SLEEP timer icon on the screen when a sleep timer is set. You
can check the sleep time remaining by returning to the Sleep timer menu.
You can also access the Sleep timer directly using the SLEEP button on the
remote control.
Setting clock, timer and alarms