Pure Sirocco 550 - User Guide - Manual (Page 6)

6
Using an Ethernet connection to your network
The optional PURE mini USB Ethernet adapter enables Sirocco 550 to use a wired network
connection rather than using a wireless connection. Connect an Ethernet (RJ45) cable from your
router to the socket on the adapter and connect the adapter to the mini USB port on the rear of
Sirocco 550.
Setup your connection
If you selected Ethernet as your connection type during the first start up of Sirocco 550 (or after a
factory reset), you should now be connected to your network.
To change your connection type to Ethernet
From either the Lounge or Media Player sources, press Options and select Network settings >
Select network type > Ethernet . Sirocco 550 will apply the new setting and connect to your network.
The status of your connection is indicated by the network status icon on Sirocco 550’s display:
Active wired connection Wired connection inactive/disconnected
Adapter status lights
100Mbps Lit when adapter is working at full connection speed (100 Megabits per second)
LAN Flashes on and off to indicate network activity
USB Lit when correctly connected to Sirocco 550 USB port
Troubleshooting
• If any of the status lights do not light up, check that all cable connections are secure, and that
both Sirocco 550 and your internet connection are working correctly.
• Try clearing your network settings (Press Options and select Network settings > Clear network
settings )
• If you still experience problems, perform a factory reset. (Press and hold Options until you see
the Factory reset confirmation screen). This will restore Sirocco 550’s settings to their default
and you will be able to select Ethernet as your connection type during startup.
RJ45 Socket
Connect the
cable from your
router here
Mini USB connector
For connecting to
Sirocco 550
Adapter Status lights
Lit when active (see right)