Outback Power Systems AXS Port SunSpec Modbus Interface Owners Manual - Manual (Page 8)

Operation
6 900-0138-01-00 Rev B
Cabling
If a single OutBack product is used, it can connect directly to the AXS Port. If multiple OutBack
products are networked on an OutBack HUB, the HUB can connect to the AXS Port.
-
Figure 4 Cabling
Figure 5 Accessories
¾ If the optional temperature sensor (the
OutBack RTS) will be used, secure the RTS to
the surface being monitored. Insert the RTS
into the Temperature Sensor port.
¾ If the microSD card will be used for
logging data, insert the card into the slot.
When the SD card is inserted correctly, the
SD Card LED will illuminate. (See Figure 6.)
Micro
SD Card
Slot
Temperature
Sensor
Port
NOTE: Orient the microSD card with the
conductors facing down. The angled
corner enters on the right of the slot.
OutBack
Device
Cable
Network
Cable
1. Connect the CAT5 cable from the OutBack device to the connection labeled “HUB
Port” on the AXS Port. The Power LED will illuminate. (See Figure 6.)
2. Connect the network cable to the connection labeled “Network Port” on the AXS Port.
3. Connect the other end of the network cable to the network or Internet. When an
Ethernet link is established, the Ethernet Link LED will illuminate.
(See Figure 6.)
HUB/Device
Port
Network
Port
Internet
Internet
AXS Port
AXS Port
OutBack HUB
OutBack
Products
OutBack Charge
Controller