Outback Power Systems FLEXware 500 Users Guide - Manual (Page 9)

T M T M
13
MX60 Installation
A FLEXware 500 System will normally have up to two MX Charge Controllers installed on the
FW500-DC. The chassis accommodates both side and top installation. Newer MXs have rear
knockouts allowing them to be mounted directly to the side of the enclosure without the need for
additional mounting brackets. Mounting brackets are available for top installation of all MX models
and for side installation less recent models.
Bracket screw locations are
shown below Screw locations for directly attaching an
MX Charge Controller are shown below
Figure 13:
MX Charge Controller mounting options
Figure 4: First FX installed
With the Mounting Plate and the hanging screws (for the FX Inverter/Chargers) inserted,
install the FXs.
• Start with the top FX.
• Hang the FX on the hanging screws, but continue to hold onto it.
• Loosely install four M6 X 20 mm screws, included with the FW-MP, one in each corner; tighten
them when all four are installed and the FX is aligned.
• Install the remaining FX in the same manner.
AC side DC side
Figure 5: Both FXs installed
6