Outback Power Systems GS Load Center Installation Manual - Manual (Page 28)

Installation
26 900-0123-01-00 Rev C
Figure 23 Mounting the GSLC (continued)
7. Realign the GSLC along the bottom of the inverter and slide the mounting screws into the keyhole slots.
8. Secure the enclosure to the mounting surface using all four mounting feet holes.
9. Using the bolts provided on the Radian inverter’s battery terminals, connect the terminals to the GSLC’s
inverter bus bars. Tighten to the value shown in Table 1 on page 19. For more information on the Radian
terminals, see the Radian Series Inverter/Charger Installation Manual.)
10. Leave the door and interior cover removed until all components have been installed and all wiring is
complete.
Bottom Screws
Keyhole Slots
Keyhole Slots
...continued from the previous page.