Introduction, Audience, Welcome to outback power technologies – Outback Power Systems GS3548E Installation Manual User Manual
Page 5
3
Introduction
Audience
This book provides instructions for the physical installation and wiring of this product.
These instructions are for use by qualified personnel who meet all local and governmental code
requirements for licensing and training for the installation of electrical power systems with AC and DC
voltage up to 600 volts. This product is only serviceable by qualified personnel.
Welcome to OutBack Power Technologies
Thank you for purchasing the OutBack Radian Series Inverter/Charger. This product offers a complete
power conversion system between batteries and AC power. It can provide backup power, sell power
back to the utility grid, or provide complete stand-alone off-grid service.
Figure 1 Radian Series Inverter/Charger
NOTE: This product has a settable AC output range. In this book, many references to the output refer
to the entire range. However, some references are made to 230 Vac or 50 Hz output. These are
intended as examples only.
Designed to be integrated with other components as part of
an OutBack Grid/Hybrid™ system
Battery-to-AC inverting which delivers single-phase power
(220 to 240 Vac at 50 or 60 Hz)
Model GS7048E can continuously produce 7 kVA (30 Aac)
Model GS3548E can continuously produce 3.5 kVA (15 Aac)
Mounts easily with supplied mounting plate
All terminals exit at the bottom of the inverter, allowing the
installer to use a single distribution box; the GS Load Center
(GSLC) is specifically designed for this purpose
Uses spring-based AC terminals instead of screw-based
terminals; this eliminates torque requirements and periodic
re-tightening
Uses the MATE3™ System Display and Controller (sold
separately) for user interface as part of a Grid/Hybrid system
Uses the HUB™ Series Communications Manager for
networking as part of a Grid/Hybrid system
Features versatile mounting locations for the MATE3, HUB
product, FLEXmax charge controller, and GSLC
The venting on the cover allows mounting of multiple Radian
inverters side by side with minimal clearance between them
Up to 10 Radian inverter/chargers can be stacked together