Night Owl PE-DVR8 user manual - Manual (Page 78)

78
Chapter 21: Remote Access
21.2 Windows Network Configuration
In this section you will determine basic information about your network
Make sure that the DVR is properly connected to the router/modem and
that you have a Windows computer connected to the same router.
Follow these steps to determine the basic information about your network:
1. Press the Windows key and the R key at the same time on your
computer’s keyboard. Type cmd and press the Enter key.
2. In the command prompt window, type ipconfig and press Enter.
Find the section called “Ethernet adapter Local Area Connection” or
“Wireless LAN Adapter Wireless Network Connection.”
3. Find the IPv4 Address (it may be named “IP Address” in some
versions of Windows). Write down this number.