Night Owl PE-DVR4 user manual - Manual (Page 58)

Chapter 15: Advanced Menu
58
15.4 PTZ Menu
The PTZ Menu allows you to configure settings on your DVR to control a
PTZ (Pan Tilt Zoom) camera. (PTZ camera not included.)
To access the PTZ Menu, select the Advanced button and then select
P.T.Z. from the list on the left side of the screen.
Refer to your PTZ camera’s documentation for proper settings.
• CH: Indicates the channel that you will be configuring.
• Enable: Allows you to enable/disable the PTZ controls. To enable
the controls, ensure that there is a check mark in the box.
• Protocol: Select PELCO-D or PELCO-P for the selected channel.
•
Baud Rate: Select 1200, 2400, 4800, or 9600.
• Address: Enter an address from 001 to 255.
• Copy CH: Allows you to configure the settings for one channel and
copy them to another channel.
• To CH: Allows you to choose the channel to be copied.
Refer to your PTZ camera’s instruction manual for further details.
PTZ camera is not included. Please keep in mind the Protocol
and Baud Rate settings are configured specific to your camera.
Night Owl cameras must be set to Pelco-D and 9600.