Dee Zee DZ760082 - Manual (Page 4)

one M10 (16mm) Lock Washer and one M10 (16mm) Nut will be installed to the bottom
of the Brace Bracket (Fig.7). Repeat steps for all Brace Bracket Tray mounts on the top
and bottom (Fig.8). Hand tighten.
(Fig.6) (Fig.7) (Fig.8)
(Step4): With all blots installed proceed to tighten all bolts until secure.
(Step5): Insert Receiver Rack into receiver hitch of the vehicle (Fig.9-10) using only a
certified hitch pin (NOT INCLUDED). Failure to use a certified hitch pin may cause
injury and or damage to your vehicle, other vehicles, and cargo.
(Fig.9) (Fig.10)
All bolts and nuts should be tightened and secured prior to installing, adding cargo
or departing. Always secure your cargo with some type of tie down system to ensure
that cargo does not fall off Receiver Rack. DO NOT place valuables or any other
items on the Receiver Rack that could be damaged by adverse weather or road
debris. CHECK EXHAUST location prior to adding cargo. Prolonged exposure to
high temperature exhaust could result in damage to cargo or possible a fire hazard.
It is the user’s responsibility to properly secure cargo and check for listed hazards
prior to use. NEVER exceed the weight limit of the Receiver Rack (200Lbs – evenly
distributed).