Dee Zee DZ760082 - Manual (Page 3)

Installation Instructions:
(Step1): Place Rack Trays onto level floor. Overlap Trays as shown in (Fig.1). Position
Rack Tray Connector plates using M6 (10mm) bolts, flat washers, lock washers and
Nylock® nuts as shown in (Fig.2). Insert bolt from the outside using one flat washer.
From the inside place one flat washer; one lock washer and one nut onto bolt and hand
tighten.
(Fig.1) (Fig.2)
(Step2): With connector plates in position place rack on its side and place the 2”
Receiver Bar to the bottom of the rack. Align the three mounting holes (Fig.3). Install the
one M10 X 75mm (Full Thread) Bolt and one M10 (16mm) Flat Washer from the inside
of the rack through the center hole. Attach one M10 (16mm) Flat Washer, one 10M
(16mm) Lock Washer, and one 10M (16mm) Hex Head Nut and hand tighten (Fig.4-5).
(Fig.3) (Fig.4) (Fig.5)
(Step3): Attach upper Brace Bracket to Receiver Center Bar using one M10 X 75mm
(1/4 Thread) Bolt. Place washers and nuts in same sequence used in step 2. Lock Washer
and Nut should be mounted to the bottom of the Receiver Tube. Repeat step for lower
Brace Bracket (Fig.6). Attach the Brace Bracket to the Rack Tray (Fig.7). Each side of
the Brace Bracket will require one M10 X 25mm Bolt with one Flat Washer inserted
from the inside of Rack Tray and through Brace Bracket. One M10 (16mm) Flat Washer,